+- Punaweb Forum (http://punaweb.org/forum)
+-- Forum: Punaweb Forums (http://punaweb.org/forum/forumdisplay.php?fid=3)
+--- Forum: Punatalk (http://punaweb.org/forum/forumdisplay.php?fid=10)
+--- Thread: Cylinder Head valve job and machining? (/showthread.php?tid=14765)
Cylinder Head valve job and machining? - Wao nahele kane - 10-05-2014
Commercial Diesel head, any recommended shops around here?
RE: Cylinder Head valve job and machining? - mac nut - 10-05-2014
big island machine in hilo. little pricey, but good work
RE: Cylinder Head valve job and machining? - dmbwest - 10-05-2014
mac nut,
What did you have done and please define what you mean by "pricey" if you would not mind + compared to what ?
mahalo,
pog
RE: Cylinder Head valve job and machining? - Wao nahele kane - 10-05-2014
Thanks Mac nut I'll give them a call in the AM.
Pog, other thread related. Hang in there, the first one takes a while to get over but... there's a whole new adventure ahead. I've rolled through 4 and with the exception of one, they all cost me and I had to start from scratch again. As they say, it is what it is.