09-06-2016, 04:08 PM
These heaters cut out if the water flow becomes too slow in order to prevent the equipment from being damaged by the water boiling before it makes it through the heat exchanger.
There is a control on the front regulating the minimum flow rate. Read the manual.
For showering, establish a healthy hot water flow, then regulate temperature with the cold water valve. Leave the hot water valve alone once the hot water flow is established.
You need to establish a healthy hot water flow, because the back pressure from the cold water can lower the flow rate of the hot water until it shuts down.
Been using one several years. No problems.
---------------------------
You can't fix Samsara.
There is a control on the front regulating the minimum flow rate. Read the manual.
For showering, establish a healthy hot water flow, then regulate temperature with the cold water valve. Leave the hot water valve alone once the hot water flow is established.
You need to establish a healthy hot water flow, because the back pressure from the cold water can lower the flow rate of the hot water until it shuts down.
Been using one several years. No problems.
---------------------------
You can't fix Samsara.