Speaking of Rust

[Royall]

When I moved my WW tools over, I broke them down to fit into boxes. Any bare iron I sprayed with cosmoline and wrapped it in cardboard. I found it was easier to pack tools when all the accessories were removed and boxed separately. I put the nuts and bolts in double freezer bags and labeled them as to which tool they went to. My 3hp Delta was a lot of work. I built a special pallet and strapped it to the pallet with ratchet tie downs. I took the table extension off, sprayed them with the cosmoline, wrapped them in cardboard and then with shrink wrap film. I also wrapped the table saw base with the shrink wrap before strapping it to the pallet. Did all this for the bandsaw, joiner, etc..... Just don't lose the packages of nuts and bolts to put them back together! Those are some special items and expensive to get. Don't leave any tool behind, you WILL kick your self in the butt after you get here when you go to TRY and replace it! Have fun and give me a call when you get here!

Royall

Hale O Na Mea Pa`ani

PS. If you have a bandsaw, don't ship it with the table attached. The trunnions are very easy to brake!!