Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Lower Puna's New Access Roads
#1

To be honest I have not been following the development of the Lower Puna access routes very closely.
This my have been covered.
But, I don't see where.

So, as I understand it, RR, Beach and the newly restored portion of CoC over the south-side lava flows, will all be gravel [maybe even dirt] surfaces.
The portion of CoC that presently exists on the Park side, and climbs the mountainside to join 11, is paved, or at least was the last time I drove over it.

If they have to carry the traffic it seems they will need to, RR, Beach and the "new" portion of CoC will, almost within hours, become pot-holed, washboarded nightmares.
Is there a plan to continually re-grade the road surfaces to keep them smooth enough to keep traffic flowing?

The existing paved portion of CoC:
Is it in the plan to upgrade the road surface to carry the loads imposed by the increased traffic including trucks?
If not, it also will very quickly become a pot-holed, washboarded nightmare compounded by the climb.
- - - - - - - - - - -
Was a Democrat until gun control became a knee jerk, then a Republican until the crazies took over, back to being a nonpartisan again.
This time, I can no longer participate in the primary.
Reply


Messages In This Thread
Lower Puna's New Access Roads - by 1voyager1 - 10-29-2014, 04:49 AM
RE: Lower Puna's New Access Roads - by PaulW - 10-29-2014, 06:49 AM
RE: Lower Puna's New Access Roads - by 1voyager1 - 10-30-2014, 11:39 AM
RE: Lower Puna's New Access Roads - by punalvr - 10-30-2014, 02:20 PM
RE: Lower Puna's New Access Roads - by JohnDW - 10-30-2014, 05:38 PM
RE: Lower Puna's New Access Roads - by Rene - 10-30-2014, 07:54 PM
RE: Lower Puna's New Access Roads - by macuu222 - 10-31-2014, 02:49 AM
RE: Lower Puna's New Access Roads - by kalakoa - 10-31-2014, 03:15 AM
RE: Lower Puna's New Access Roads - by kander - 10-31-2014, 08:21 AM
RE: Lower Puna's New Access Roads - by JohnDW - 10-31-2014, 02:16 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)