Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
O'o Bar
#23


Mark,

I did something very similar, drilled using 18in long 2in wide bit and pounded two 3in gate posts into ground before filling with cement. Backed truck right up to the gate post and pounded in from the bed - very easy.
Reply


Messages In This Thread
O'o Bar - by microage97 - 03-21-2014, 02:55 AM
RE: O'o Bar - by allensylves - 03-21-2014, 03:00 AM
RE: O'o Bar - by lquade - 03-21-2014, 03:43 AM
RE: O'o Bar - by microage97 - 03-21-2014, 03:44 AM
RE: O'o Bar - by unknownjulie - 03-21-2014, 03:54 AM
RE: O'o Bar - by microage97 - 03-21-2014, 04:10 AM
RE: O'o Bar - by Mimosa - 04-01-2014, 08:37 PM
RE: O'o Bar - by microage97 - 04-02-2014, 02:25 AM
RE: O'o Bar - by HPPGuy - 04-02-2014, 03:34 AM
RE: O'o Bar - by Seeb - 04-02-2014, 05:06 AM
RE: O'o Bar - by heyyou - 04-26-2014, 10:03 AM
RE: O'o Bar - by Punaperson - 04-26-2014, 12:53 PM
RE: O'o Bar - by microage97 - 04-28-2014, 01:42 AM
RE: O'o Bar - by kalakoa - 04-28-2014, 04:52 AM
RE: O'o Bar - by microage97 - 04-28-2014, 07:09 AM
RE: O'o Bar - by Rene - 04-28-2014, 08:57 AM
RE: O'o Bar - by microage97 - 04-28-2014, 02:59 PM
RE: O'o Bar - by MarkP - 04-28-2014, 05:25 PM
RE: O'o Bar - by microage97 - 04-29-2014, 12:26 AM
RE: O'o Bar - by unknownjulie - 04-30-2014, 12:36 AM
RE: O'o Bar - by microage97 - 04-30-2014, 01:01 AM
RE: O'o Bar - by microage97 - 04-30-2014, 01:09 AM
RE: O'o Bar - by rainyjim - 04-30-2014, 01:29 AM
RE: O'o Bar - by MarkP - 04-30-2014, 06:59 AM
RE: O'o Bar - by rainyjim - 04-30-2014, 07:09 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)