|
16mm projector
|
06-24-2017, 04:55 PM
After doing some research, the job is doable but will take many hours as you found out. I found on person that epoxied the gear(evidently it was only cracked) and cleaned up the teeth... I'm sure it would be cheaper to find a good used one. It's a shame too... the machine is a work of art on the inside. I think it would cost about $250 plus parts to get it going again.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
16mm projector - by terracore - 06-24-2017, 05:13 AM
RE: 16mm projector - by Royall - 06-24-2017, 08:31 AM
RE: 16mm projector - by terracore - 06-24-2017, 12:17 PM
RE: 16mm projector - by Rob Tucker - 06-24-2017, 01:50 PM
RE: 16mm projector - by Royall - 06-24-2017, 04:55 PM
RE: 16mm projector - by terracore - 06-25-2017, 10:24 AM
RE: 16mm projector - by MarkP - 06-25-2017, 02:53 PM
RE: 16mm projector - by terracore - 01-14-2019, 01:02 PM
RE: 16mm projector - by dan d - 01-16-2019, 01:32 AM
RE: 16mm projector - by Guest - 01-16-2019, 06:22 AM
RE: 16mm projector - by terracore - 01-16-2019, 12:02 PM
RE: 16mm projector - by Guest - 01-16-2019, 12:26 PM
|
