10-06-2018, 12:16 PM
Lay the shaft on something solid (a pallet works well, doesn't scratch the paint/galvanized coating), fin down, pound with small sledgehammer until it comes off -- the fin is press-fit, not welded to the post.
|
T post question
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
T post question - by Mindful - 10-06-2018, 12:10 PM
RE: T post question - by kalakoa - 10-06-2018, 12:16 PM
RE: T post question - by terracore - 10-13-2018, 09:15 AM
RE: T post question - by MarkP - 10-13-2018, 11:01 AM
RE: T post question - by terracore - 10-14-2018, 06:31 AM
RE: T post question - by MarkP - 10-15-2018, 01:42 AM
RE: T post question - by My 2 cents - 10-15-2018, 03:28 AM
RE: T post question - by kalakoa - 10-15-2018, 04:00 AM
RE: T post question - by terracore - 10-15-2018, 01:28 PM
RE: T post question - by MarkP - 10-15-2018, 09:52 PM
RE: T post question - by terracore - 10-16-2018, 01:15 PM
|
Users browsing this thread: 1 Guest(s)