01-08-2009, 07:01 PM
This might sound a little wild, but paint the walls with a non impervious, rust coating, all sides, top and ends. Now lay the unit on one side, apply masonry bonding agent to both out and inside walls. Now pour a levelling coat of lightweight concrete to both sides.
Flip over and treat the other side the same. Should give two bulletproof, insulated walls.
For the ends, pieces could be precast, and actually, with mold release, the whole unit could be precast as individual strips and applied in the field.
For horizontal holding, mabe cheap strapping tape applied with a spot welder for minimum damage to container. I think spot welding could be the one for most lighteight holding.
Flip over and treat the other side the same. Should give two bulletproof, insulated walls.
For the ends, pieces could be precast, and actually, with mold release, the whole unit could be precast as individual strips and applied in the field.
For horizontal holding, mabe cheap strapping tape applied with a spot welder for minimum damage to container. I think spot welding could be the one for most lighteight holding.
Gordon J Tilley