06-22-2009, 12:05 PM
Dicks last post is good advice. Yep, in the trades. Splicing 10/3 into 4 or 6 ga. no good.
BTW. If you want a tradesman who is not licensed or insured by comp to work for you, you can always run them through an employment service.
My advice is to get an electrician for this drop project. jerry on this board is very good.
BTW. If you want a tradesman who is not licensed or insured by comp to work for you, you can always run them through an employment service.
My advice is to get an electrician for this drop project. jerry on this board is very good.